Dear friends, this is the mods.dk Newsletter.
In this Edition, you will find a list of all the new & updated articles now on our site.
Created: 06-04-2011 Icom IC-756PRO3 | |
Subject: Yaesu MD100 A8X to Icom IC-756PROIII | |
Making a cable to use Yaesu MD100 A8X microphone with a Icom IC-756PROIII
radio. Use one UTP Ethernet cable RJ45 Pin 1 - white/orangeMIC 756PROIII... |
Created: 28-04-2011 Icom IC-R7000 | |
Subject: IC-R7000 Audio modifications | |
The following modifications provide the following facilities. - base band
audio output, to utilising digital transmissions such as AIS etc. - a CTC... |
Created: 31-05-2011 Icom IC-7410 | |
Subject: IC-7410 RX/TX modification | |
Icom IC-7410 RX and TX modification. Download the complete article. |
Created: 30-06-2011 Icom MISC | |
Subject: Modification of the Icom IC-UR8050 UHF Commercial repeater for HAM radio | |
Just picked up a pile of Icom repeaters at the Friedrichshafen HAM-fest.
I was already wondering why nobody wanted them at 150 ? new in the box. So I
... |
Created: 17-04-2011 Kenwood TS-590 | |
Subject: Kenwood TS-590 TX modification | |
The E version (Europe) has no TX on 5 MHz, but the K version (USA) has 5
MHz TX between 5.250 MHz and 5.450 MHz. According to the service manual
(page... |
Created: 17-04-2011 Kenwood TM-V71 | |
Subject: Using the Kenwood TM-V71A on digital modes | |
An unpublished feature of the Kenwood TM-V71A is that you do not need an
external interface to use the TM-V71A with FLDIGI or other digital
communicat... |
Created: 23-05-2011 Kenwood TS-2000 | |
Subject: How to migrate TS-2000 RS-232 port to USB | |
2011/05/18 SQ6EMM Dawid Szymanski Reszelska 2/2 54-113 Wroclaw
+48609626895 sq6emm@hamradio.pl http://hamradio.pl/sq6emm/ This document
will d... |
Created: 21-06-2011 Kenwood TM-V7E | |
Subject: TM-V7E frequency adjustment | |
The kenwood TM-V7E have a complete good reputation under the amateur
radio enthusiasts. He has been confessed also under the nickname the blue
wonder.... |
Created: 01-07-2011 Kenwood TS-680 | |
Subject: Kenwood TS-680S power switch repair | |
I recently turned on my TS-680S and got very odd results. It had been
working normally. But this time I got an odd squeal, and all the display
digits... |
Created: 04-04-2011 Other MISC | |
Subject: DAIWA SS-330W Power Supply Failure | |
Check resistor R8 (390K, 0.1w) located next to Power-Transistor Q3,
2SC5353, with the small heatsink. R8 goes open circuit, no sign of damage.
Repl... |
Created: 19-05-2011 Other MISC | |
Subject: Baofeng UV3-R volume modification | |
The volume on the Baofeng UV3-R lowest level is way to high so I did a
modification to the feedback loop on the PA driving the speaker. The patch
ins... |
Created: 02-06-2011 Other MISC | |
Subject: magnum raptor frequency expansion | |
Converting to 240 Channels Power OFF the radio and remove bottom cabinet.
Orientate radio with front panel Facing towards you. Locate h... |
Created: 07-06-2011 Other MISC | |
Subject: Cushcraft R5 repair | |
Some day, our clubhouse antenna system just stopped working. As it isn?t
often used, nobody can tell how and when it happened, but it was dead,
comple... |
Created: 07-06-2011 Other MISC | |
Subject: Type changing Tait Orca, Tait 5000. | |
This Technical Note applies to all Tait Orca and Tait Orca 5000 portable
radios. This Technical Note supersedes TN-530 and TN-564. These Technical
No... |
Created: 10-06-2011 Other MISC | |
Subject: Grundig YaltBoy Alignment Locations | |
I own a Grundig YB-206 and decided to do an alignment on it and at the
same time I dicumented it. I attached the zip file which contains two
pictures... |
Created: 28-06-2011 Other MISC | |
Subject: Watson W-25AM W-30AM - Repair Faulty Fan | |
A few of weeks ago the fan on my Watson W-25AM power supply started to
behave erratically and would activate at full speed with less than 1A of
load c... |
Created: 01-07-2011 Other MISC | |
Subject: GRECOM PSR 300 battery slow charging modification | |
It seems build in charger charges with too much current, which makes
battery hot. this mods make it charges lower current less than 10 mA, depend
on i... |
Created: 01-07-2011 Other MISC | |
Subject: Ten Tec OMNI-V mod to work down to 9V or so | |
TEN TEC OMNIV I have , shut down when input voltage become around 11V As
I looked at schematic of Logic CPU board, I discover that D3 1N757A , which
... |
Created: 01-07-2011 Other MISC | |
Subject: Ten-Tec OMNI-V audio mod | |
To eliminate audio pop noise, when switch from RX to TX |
Created: 01-07-2011 Other MISC | |
Subject: Ten Tec OMNI-V power mod to 5 watt | |
Ten Tec OMNI-V power adjustable to below 5 watts |
Created: 05-05-2011 Radio Shack PRO-137 | |
Subject: Radio shack PRO-137 Test modes | |
Hold the listed keys to perform the listed function: NOTE: THIS MAY CLEAR
YOUR MEMORY: WHILE THESE FUNCTIONS MY MEMORY WAS CLEARED E[PGM]+1+CAR:... |
Created: 01-05-2011 Standard HX-470 | |
Subject: Extended TX / RX for the STANDARD VERTEX HX-470S VHF Marine Handheld | |
Download the article in PDF. |
Created: 11-05-2011 Uniden OTHER | |
Subject: FMU-250K, Uniden Mobiles LED Display Fix | |
For the FMU-250K and other Uniden Lowband, VHF, and UHF mobile radios
using the dual 7 segment display. The displays in these radios fail, and
usuall... |
Created: 04-04-2011 Yaesu VX-3200 | |
Subject: VX-3200 Low Microphone audio on TX | |
The TX Microphone audio gain is a bit low on this radio, and only
requires the removal of one resistor R2058, a 680 ohm resistor located on
the front ... |
Created: 07-04-2011 Yaesu MD-100 | |
Subject: Yaesu MD100 A8X External Pedal PTT | |
For free hands during "on air" operations I use a "music keyboard sustain
pedal" (normally open) connected to a pins 5 and 6 of MIC MD-100 A8X. You
c... |
Created: 27-04-2011 Yaesu FTM-10E | |
Subject: FTM-10 Motorcycle Audio System Configuration | |
Using the Yaesu FTM-10 Ham Radio and David Clark Audio Headset Hardware
Download the complte article here in Power Point file format. |
Created: 06-05-2011 Yaesu VX-8R | |
Subject: Yaesu VX-8GR MARS/CAP mode | |
If you remove the 8GR battery pack, you will see a silver-grey label on
the back of the 8GR. You should also have a spare one in the 8GR's boxed
i... |
Created: 06-05-2011 Yaesu VX-8R | |
Subject: Yaesu VX-8GR accessing the service menu | |
Program menu item 16 CW ID to ON with code AH041M. Put the radio into
single VFO (A) mode. (Press and hold the A band button.) Turn off the ... |
Created: 07-05-2011 Yaesu FT-840 | |
Subject: How cool your totally FT-840 | |
Remember that the original fan is only good when it is being transmitted
in reception which is most of the time, underneath it is very hot because
the... |
Created: 11-05-2011 Yaesu FT-7800 | |
Subject: Quieter Fan Mod for FT-7800 and FT-7900 | |
The original fan of the FT-7900 / FT-7800 is pretty loud, especially in a
quiet shack. Therefore I changed the original cooler with the "SilenX
iXtre... |
Created: 11-05-2011 Yaesu VX-170 | |
Subject: Low microphone volume for VX-170 and FT-270 | |
Turn off the Ht. Press and hold the PTT button and MONI while turning on
the radio.Appears SETRST Once on, release PTT and MONI. Press the ... |
Created: 22-06-2011 Yaesu FT-100 | |
Subject: CR2020 Battery replacement for FT-100D | |
If your rig is losing the memory frequencies, cranky, wont light, or
start up, or any unexplained problem, just change the backup CR2020 battery
and r... |
Note, sometimes it can be difficult to see the changes since the update can be a little correct in the text, but sometime the update can be a new picture to the existing article.
Updated: 07-06-2011 Icom IC-V80 | |
Subject: IC-V80 MARS/CAP | |
Note: We are not responsible for any damage to the radio. The
modification of the radio is at your own risk. Remove both the antenna and
the batt... |
Updated: 16-05-2011 Icom IC-9100 | |
Subject: Icom IC-9100 RX/TX mods (MARS/CAP) | |
RX and TX modification of IcomIC-R9100. Download the complete PDF file
here. Download also the complete MARS/CAP modification in PDF here. |
Updated: 26-05-2011 Midland/Alan 278 | |
Subject: Increse the power output 10w for Midland 278 | |
Cut the green wire for ability the power output a 10 Watt. The trimmer
power RV201. See you picture below 26th may 2001. New versions of the CB... |